5.4.1. Names, Addresses, Ports, and All That


Up: Establishing Communication Next: Server Routines Previous: Establishing Communication

Almost all of the complexity in MPI client/server routines addresses the question ``how does the client find out how to contact the server?'' The difficulty, of course, is that there is no existing communication channel between them, yet they must somehow agree on a rendezvous point where they will establish communication --- Catch 22.

Agreeing on a rendezvous point always involves a third party. The third party may itself provide the rendezvous point or may communicate rendezvous information from server to client. Complicating matters might be the fact that a client doesn't really care what server it contacts, only that it be able to get in touch with one that can handle its request.

Ideally, MPI can accommodate a wide variety of run-time systems while retaining the ability to write simple portable code. The following should be compatible with MPI:


MPI does not require a nameserver, so not all implementations will be able to support all of the above scenarios. However, MPI provides an optional nameserver interface, and is compatible with external name servers.

A port_name is a system-supplied string that encodes a low-level network address at which a server can be contacted. Typically this is an IP address and a port number, but an implementation is free to use any protocol. The server establishes a port_name with the MPI_OPEN_PORT routine. It accepts a connection to a given port with MPI_COMM_ACCEPT. A client uses port_name to connect to the server.

By itself, the port_name mechanism is completely portable, but it may be clumsy to use because of the necessity to communicate port_name to the client. It would be more convenient if a server could specify that it be known by an application-supplied service_name so that the client could connect to that service_name without knowing the port_name.

An MPI implementation may allow the server to publish a ( port_name, service_name) pair with MPI_PUBLISH_NAME and the client to retrieve the port name from the service name with MPI_LOOKUP_NAME. This allows three levels of portability, with increasing levels of functionality.

    1. Applications that do not rely on the ability to publish names are the most portable. Typically the port_name must be transferred ``by hand'' from server to client.
    2. Applications that use the MPI_PUBLISH_NAME mechanism are completely portable among implementations that provide this service. To be portable among all implementations, these applications should have a fall-back mechanism that can be used when names are not published.
    3. Applications may ignore MPI's name publishing functionality and use their own mechanism (possibly system-supplied) to publish names. This allows arbitrary flexibility but is not portable.



Up: Establishing Communication Next: Server Routines Previous: Establishing Communication


Return to MPI-2 Standard Index
Return to MPI 1.1 Standard Index
Return to MPI Forum Home Page

MPI-2.0 of July 18, 1997
HTML Generated on September 10, 2001